Loading The Media - Oki LE840 Guia Del Usuario

2. PRINTER SETUP

2.3.1 Loading the Media

NOTES:
1. When the Head Lever is
turned to FREE position, the
Print Head can be raised.
2. To enable printing the Head
Lever must be set to the
LABEL / TAG position.
(This ensures that the Print
Head is closed.)
There are two head pressure
levels in the LABEL / TAG
position. Set the Head Lever
depending on the media type:
Position LABEL: Labels
Position TAG : Tags
However, proper position
may differ depending on
media. For details, refer to
your Oki Data authorised
service representative.
The following procedure shows the steps to properly load the media into
the printer so that it feeds straight through the printer.
The printer prints both labels and tags.
1. Open the Top Cover.
2. Turn the Head Lever to the FREE position and release the Ribbon
Shaft Holder Plate.
3. Open the Print Head Block.
Print Head Block
FREE
LABEL
TAG
4. Move the Paper guide R to the rightmost position or shift the
guide to the horizontal position.
5. Put the media on the Paper Holder.
6. Pass the media around the Paper Holder, and then pull
the media towards the front of the printer.
7. Push the Paper Guide against the media until the media is
held firmly in place. To lock the Media, shift the Paper Guide
R to vertical position
E2- 5
Top Cover
Head
Ribbon Shaft Holder Plate
Lever
Paper Guide L
Paper Guide R
2.3 Loading Supplies