Copying Data To/From Usb Memory - Oki LE840 Guia Del Usuario

2. PRINTER SETUP
2.6.12 Copying Data to/from
USB Memory
SYSTEM MODE
<10>RFID
<11>RTC
<12>Z-MODE
<13>USB MEMORY
NOTE:
Usable USB memory's file system
is as follows:
File system Max. size
FAT (FAT16) 2GB
FAT32 8GB
To use USB memories of the
other file system, they need to be
formatted to either of the above
on the PC in advance.
NOTE:
If a file with the same name
already exists in the USB
memory, it will be overwritten.
The USB Memory menu allows the copying of data from a USB memory
to the printer and saving data from the printer to a USB memory.
USB memory can be used only when an optional RTC & USB Host
Interface Card is installed.
(1) USB TO PRINTER
This parameter is to copy data from a USB memory to the printer.
 COPIED DATA
 CONFIG FILE
1. When the file selection screen is displayed choose a file to be copied.
(Example)
2. When the [ENTER] key is pressed, the confirmation message is
displayed.
For the CFG files, the message included in the CFG file is displayed
prior to the confirmation message.)
3. The data is read from the USB memory. It takes 3 to 5 minutes to
read all the information.
(2) PRINTER TO USB
This parameter is to save the firmware (BOOT/MAIN/CG/
KANJI/HTML), storage area information, and parameter settings to a
USB memory.
 ALL
1. The confirmation message is displayed.
2. The data is copied to the USB memory. It takes approx. 40 seconds to
save all information.
A file is automatically created in the USB memory and named in the
following format based on the printer model and saved date.
/ATA0/SYSTEM/LE840-0927.DAT
(e.g. LE840(203dpi model), Sep 27)
E2-39
File (*.DAT) containing firmware (BOOT/MAIN/
CG/KANJI/HTML), storage area information, and
parameter settings
File (*.CFG) in which the path of the firmware
(BOOT/MAIN/ CG/KANJI/HTML) is saved
2.6 Printer Setting