Hitachi Koki C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones página 20

English
6. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45°
bevel cutting angle and right 45° bevel cutting angle with the 8 mm set screw, 8 mm bolt (A)
and 8 mm bolt (B).
When changing the adjustment, change the height of the 8 mm set screw, 8 mm bolt (A), or
8 mm bolt (B) by turning them.
When changing the bevel angle to the right 45°, pull the set pin (A) on the direction shown in
Fig. 12-b and incline the motor head to the right.
When adjusting the motor head to 0°, always return the set pin (A) to its initial position as
shown in Fig. 12-b.
8 mm bolt (B)
(Stopper for right 45° bevel angle)
Fig. 12-a
7. Securing the workpiece
WARNING:
8. Installing the holders ... (Optional accessory)
6 mm knob bolt
(Optional accessory)
Steel
Holder
square
(Optional
accessory)
Height adjustment bolt 6 mm
6 mm wing nut
(Optional accessory)
(Optional
accessory)
Fig. 13
20
Indicator
(For left bevel scale)
8 mm set screw
(Stopper for 0° not shown)
Always clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Base surface
Indicator
(For right bevel scale)
8 mm bolt (A)
(Stopper for left 45° bevel angle)
Fig. 12-b
The holders help keep longer workpieces
stable and in place during the cutting operation.
(1) As indicated in Fig. 13, use a steel square
for aligning the upper edge of the holders
with the base surface.
Loosen the 6 mm wing nut. Turn a height
adjustment bolt 6 mm, and adjust the
height of the holder.
(2) After adjustment, fi rmly tighten the 6 mm
wing nut and fasten the holder with the
6 mm knob bolt (optional accessory). If the
length of Height Adjustment Bolt 6 mm is
insuffi cient, spread a thin plate beneath.
Make sure the end of Height Adjustment
Bolt 6 mm does not protrude from the
holder.
Set pin (A)
Pull