Hitachi Koki C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones página 35

Tronzadora radial abatible
Ocultar thumbs Ver también para C 12RSH2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
CAUTION:
Position crown molding with its WALL CONTACT EDGE against the guide fence and its
CEILING CONTACT EDGE against the crown molding Stoppers as shown in Fig. 45-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
Refer to the lower table for the miter angle.
For inside corner
For outside corner
13. Groove cutting procedures
Cut grooves with saw blade
Fig. 46
Grooves in the workpiece can be cut as indicated in Fig. 46 by adjusting the 6 mm depth
adjustment bolt.
Cutting depth adjustment procedure:
(1)
Turn the stopper holder on the direction shown in Fig. 47.
Lower the motor head, and turn the 6 mm depth adjustment bolt by hand. (Where the
head of the 6 mm depth adjustment bolt contacts the hinge.)
Always fi rmly clamp or vise to secure the crown molding to the
fence; otherwise the crown molding might be thrust from the
table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the
sub fence, resulting in an injury.
Always confi rm that the motor head (see Fig. 1) does not contact
the crown molding vise ass'y when it is lowered for cutting. If there
is any danger that it may do so, loosen the hex. socket set screw
and move the crown molding vise ass'y to a position where it will
not contact the saw blade.
Position in Fig. 36
1
2
3
4
6 mm depth
adjusatment bolt
Miter angle
Right 45°
Save the right side of blade
Save the left side of blade
Left 45°
Save the right side of blade
Right 45°
Save the left side of blade
Turn
Stopper
holder
Hinge
Fig. 47
English
Finished piece
Bottom line of
the groove
Turntable
35

Publicidad

Tabla de contenido
loading

Tabla de contenido