Publicidad
Idiomas disponibles
Idiomas disponibles
7.5. RECOMENDATIONS
Always cut the grass when it is dry. Avoid mowing
the lawn when it is wet after having watered or after
having rained.
Cut less than 2 cm of grass at a time. If your lawn is
very high, it is advisable to make successive passes
with the 2 cm cutting height every time. So no it will
force both machine.
Cut your lawn often, at least once a week in spring
and summer.
Do not always make the same route when mowing. It
is best to change your route to avoid the grass being
cut in the same direction.
If you need to move the mower between two lawn
areas always first switch off the mower.
Sharpening the blade: A dull blade requires more
energy. A dull blade also cuts badly and makes the
grass yellow.
To obtain a green and bushy lawn, it is necessary to
frequently cut and aerate it regularly, providing the
necessary manure or fertilizer.
The cutting frequency will depend on growth (May-
June). You will need to cut one or two times a week.
At other times of the year, it will be enough to cut it
only once a week.
7.6. AFTER USE
Once you stop using the machine, disconnect the
batteries from the machine.
7.7. BATTERY CHARGE
The supply voltage and current must comply with
the information on the nameplate of the charger.
Before using the battery for the first time charge it for
at least 1 hour for the 4 Ah and 40 min for the 2 Ah
To charge the battery, plug the charger into the mains,
the led will light up red. Put the battery in the charger,
the led will turn green and start blinking. The charger
LED will turn from flashing green to solid green
when the battery is fully charged. When the battery
is charged, remove it from the charger. If you leave
the battery in the charger and it is fully charged, the
charger will automatically turn off after 2 hours, with
the green LED still on.
If you insert the battery in the charger and the LED
starts flashing red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Important! If you fully charge your battery,
disconnect it from the charger and reconnect it
without using it, the LED may start flashing red
(broken battery signal) when it detects that the battery
does not accept a charge. In this case the flashing red
LED does not mean that the battery is damaged.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged. To check the
status of your battery, press the black button and the
green LED will light indicating your battery's charge
39/116
English
Publicidad
