Publicidad
Idiomas disponibles
Idiomas disponibles
3. The up/down buttons can be used to switch between On and Off. After
selecting On or Off, press the confirmation button to finalize the selection.
• On: Sound lamp turns on (sound enabled).
• Off: Sound lamp turns off (sound disabled).
NOTICE
Even if the sound setting is off, the robotic cleaner can sound to notify of an error,
etc.
Switching the sound setting on and off with the
remote control
With the robotic cleaner set in the stand -by state, pressing the sound ON/OFF
button of the remote control allows the sound setting to be switched between on
and off.
The sound setting can be switched on and off even during cleaning if it is set from
the remote control.
Resetting the settings
You can reset the settings of the robotic cleaner to the factory defaults.
1. Put the robotic cleaner into the stand -by state. (See page 15.)
2. Hold down the down button and the setting button.
[dEL] is displayed on the time indicator, and the icons and lamps other than
the error lamp blink.
3. Press the confirmation button while [dEL] is displayed (about 10 seconds).
• If the confirmation button is not pressed while [dEL] is displayed, the robotic
cleaner goes back to the stand -by state.
• When the robotic cleaner is executing the reset process, the icons and lamps
other than the battery power lamp turn off. Although the robotic cleaner will
not work at this time even if you press the buttons on the operation panel, do
not touch the buttons. In addition, do not remove the batteries.
4. Upon completion of the reset process, a restart is performed and then the
time -of -day setting screen appears.
Pairing the robotic cleaner and the remote control
When the remote control is replaced with a new one, establish a pairing of the
robotic cleaner and the remote control.
1. Hold down the smartphone connection button and the setting button
simultaneously to make [PAIr] appear on the time indicator.
[PAIr] is displayed for 10 seconds.
2. During the period when [PAIr] is displayed, simultaneously press the action
button (down) and the sound ON/OFF button of the remote control.
When pairing is successful, the robotic cleaner issues two short beeps and
returns to the standby state.
NOTICE
• If pairing fails, an error sound is made.
• If the robotic cleaner cannot receive a signal from the remote control during
the period when [PAIr] is displayed, the robotic cleaner goes back to the
stand -by state.
23
ENGLISH
Publicidad
