Sonesse 40 WireFree RTS Li-ion
Attention
• Use power charger (recommended by Somfy) to charge the drive battery.
• Ensure battery is fully charged prior to installation on site.
• Before setting, it is necessary to charge the battery only if the LED blinks red 5 times when
you press any button on the paired control point.
The drive head in details :
Antenna
a
LED
b
PROG. button
c
Plug for charger
d
1) Connect the charger to the drive.
2) When charging is complete, disconnect and
store charger for later use.
͉
͉
The drive will go back to sleep if left untouched
for 15 minutes. To wake up the drive, see 2.3.1.
Wake up the drive.
2.3. COMMISSIONING
͉
͉
Orange LED blinks continously in setting mode.
͉
͉
Green LED blinks once when any order from paired remote is received.
2.3.1. Wake up the drive
For initial unpackaging of drive, wake up the drive by briefly
pressing the drive head programming button or plugging on the
charger.
The motorised product briefly moves Up and Down 3 times and
LED lights orange.
2.3.2. Preprogramming the control point
Press the UP and DOWN buttons simultaneously on the control
point:
The motorised product moves Up and Down and the control
point is temporarily programmed to motorised product.
2.3.3. Checking the rotation direction
Press the control point UP button:
a) If the motorised product raises, the rotation direction is
correct: proceed to section «Setting the end limits».
b) If the motorised product lowers, the rotation direction is
incorrect: move to the next step.
• b1) Press the control point MY button until the motorised
product moves Up and Down: the rotation direction
has been modified and green LED blinks 5 times.
• b2) Press the control point UP button to confirm the
rotation direction.
Copyright
©
2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
a
b
c
d
LED illuminates
Solid Red LED.
Green LED blinks twice
every 10 seconds.
Solid Green.
b1
EN
Behaviour
Charging.
Charging is near
completion.
Charging is complete.
3x
a
2.3.4.
=
b
=
b2
3