AD Instruments AD6810 Manual De Usuario página 86

AD Instruments
_______________________________________________________________________________
1. Coupling Assembly
2. Flexible Loop
Open the coupling connector and circle around the conductors. Then re-connect the coupling
connector.
3. + 3Φ Button
. Increment value by 1
. Move the reference axis up
. Move the line cursor right to previous harmonics
. Page up to next transient events
. Select balanced 3Φ power measurement
4. - Button
. Decrement value by 1
. Move the reference axis down
. Move the line cursor left to next harmonics
. Page down to next transient events
5. FUNC and On/Off Button
Press this button to select different display.
Hold the button for about 2 seconds to turn the unit on or off.
6. LCD
This is a dot matrix LCD with backlight.
7. .HOLD/CANCEL/BACK LIGHT
Press this button to HOLD the display in LCD, or turn the backlight on or off.
It is also used to delete harmonics in the harmonics configuration.
8. REC
Press this button to start data logging. Press again to stop. Holding the button and turning the
power on will clear the data memory.
It is also used to add harmonics in the harmonics configuration.
9. Sliding Switch
Select setup, measurement of current, voltage, transient detection, or power.
10. COM Terminal
This terminal is used as common voltage reference input.
11. V Input Terminal
This terminal is used as input for voltage.
12. Battery Cover
13. LED
LED blinks when the unit is datalogging. LED flashes when it is detecting transients.
©Copyright Abacanto Digital SA.
86
Manual de usuario AD6810