Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
PRE-INSTALL
NETWORK
MOUNTING/POWER
ACCESS CONTROL
Wall Installation
1. Drill (2) pilot holes, spaced 7 in. (17.78 cm) apart, on the wall where the device will be mounted.
2. Use (2) #6 Phillips mounting screws (not included) to attach the device to the wall.
NOTE: For exterior mounting, LiftMaster recommends the use of a polycarbonate NEMA enclosure.
7 in. (17.78 cm)
1.3 in. (3.3 cm)
OUTPUT
WIEGAND
INPUT
1
2
1
2
GATE
OUTPUT
WIEGAND
INPUT
POWER
SDA SCL
NO COM NC
NO COM NC
D1 COM D0
D1 COM D0
1 GND 2
GND 12V-24V
POWER
ETHERNET
External Antenna Installation
For best cellular coverage position the antennas in the orientation
shown below (perpendicular to each other).
13
Publicidad
