Makita DFJ212A Manual De Instrucciones página 12

PARTS DESCRIPTION
► Fig.1
1 Fan unit
5 Battery BL1055B *
(Country specific)
* Optional accessory
► Fig.2
1 Battery pocket
5 Mesh pocket for ice pack
9 Zip fastener (for fan unit
access)
NOTE: The features of the jacket/vest vary depending on the model. Refer to the section for the specifications for
the features of your jacket/vest.
INSTALLATION
Charging the battery
Battery cartridges used with battery holder
Refer to the instruction manual of the charger for how to
charge the battery.
Battery BL1055B
Open the cover on the USB port. Connect the battery
and AC Power Adapter ADP07 (not included) or other
general USB charger using the USB cable supplied with
the battery. The recommended output spec for general
USB charger is 5 V / 2.4 A or lower. After that, plug
the AC Power Adapter ADP07 to the mains. When the
charging is finished, all battery capacity indicator will
light up and then turns off after a certain period. Unplug
the AC Power Adapter and disconnect the USB cable,
and then close the cover.
► Fig.3: 1. AC Power Adapter ADP07 2. Battery
BL1055B 3. Cover 4. USB cable
Meaning of the indicator lamp
Indicator lamps
Lighted Off
(The lamps go off after a certain period.)
2 Power cable
6 CXT battery cartridge *
(10.8 V - 12 V max)
2 Light reflector
6 Cable hole in the pocket
(under the lining)
10 Front buckle
Remaining
capacity
Blinking
100%
(The charging
is finished)
50% to 100%
25% to 50%
Less than
25%
3 Battery holder for CXT
battery cartridge *
7 LXT battery cartridge *
(14.4 V / 18 V max)
3 Hood
7 Cable holder
- -
Installing or removing the battery
cartridge
Only when using the battery cartridge used with
battery holder
CAUTION:
Always switch off the device
before installing or removing the battery
cartridge.
CAUTION:
Hold the battery holder and the
battery cartridge firmly when installing or remov-
ing the battery cartridge. Failure to hold the battery
holder and the battery cartridge firmly may cause
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
► Fig.4: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
12 ENGLISH
4 Battery holder for LXT
battery cartridge *
- -
4 Shoulder pad
8 Cable hole in the lining
- -