HOMCOM A90-256 Manual De Instrucciones página 24

ASSEMBLY INSTRUCTIONS
Assembly step 4
A.) Handle Bar Assembly
Insert the Right Handle Bar(#10) into the opening at the end of the Right Coupler Bar(#05)and
secure it by inserting two Carriage Bolts(#36)and fastening with two Arc Washers(#47),two
Spring Washers(#52)and two Nuts(#43).
Repeat this process on the left side using Left Handle Bar(#09)and Left Coupler Bar(#04).
B.) Pulse Handle Bar Assembly
Align and attach the Pulse Handle Bar(#11)to the bracket on the Center Post(#03). Secure
together using two Bolts(#37)through two Spring Washers(#52)and two Washers(#51)as
illustrated.
Monitor Assembly
Remove the four Bolts(#41)that are pre-assembled on the Monitor(#12)and set them aside
nearby.Connect the Monitor Wire (Upper)(#21)to the Monitor Wire (Middle)(#20). Secure the
Monitor(#12)to the bracket of the Center Post(#03)with the four Bolts(#41)that were previously
set aside. Next, connect the Hand Pulse Cable(#22)by plugging it into the hole on the back of
the Monitor(#12).
Bolt
#36 Carriage Bolt(M8*45MM)
[4 pieces]
Washer
#47 Arc Washer (M8)
[4 pieces]
Hardware Required
#37 Bolt (M8*35MM)
[2 pieces]
#51 Washer (M8) #52 Spring Washer (M8)
[2 pieces] [6 pieces]
-24-
#41 Bolt (M5*10MM)
[4 pieces]
Nut
#43 Nut (M8)
[4 pieces]