Applications; Conformity And Approval; Operation; Connections - Monacor International JTS UF-20S/5 Manual De Instrucciones

3 if malfunctions occur
In any case the units must be repaired by skilled
personnel
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the units and no
liability for any resulting personal damage or
material damage will be accepted if the units
are used for other purposes than originally
intended, if they are not correctly connected
or operated, or if they are not repaired in an
expert way
If the units are to be put out of oper-
ation definitely, dispose of the units in
accordance with local regulations

2 Applications

Combined with a matching transmitter from JTS,
the receiver UF-20R /5 or UF-20S/5 creates a wire-
less audio transmission system which is ideally
suited for professional stage applications The
REMOSET function is a most convenient feature
®
for operating the system: Simply press a button
and, via a 2 4 GHz radio signal, the microphone/
pocket transmitter is matched to the transmission
frequency selected on the receiver
The receivers use "True Diversity" technol-
ogy: The signal sent from the wireless micro-
phone or pocket transmitter is received by two
antennas and amplified in two separate receiver
sections The signal of the highest quality is then
processed The transmission range depends on
local conditions; in open-field conditions, the
minimum range is 100 m
The following JTS transmitters can be combined
with the receivers:
JSS-20 / 5 Order No 25 7200
Dynamic hand-held microphone with integrated
transmitter
UF-20TB / 5 Order No 25 7230
Pocket transmitter for JTS microphones with
4-pole mini XLR plug
16

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the products UF-20R / 5 and UF-20S / 5 comply
with the directive 2014 / 53 / EU The EU declara-
tions of conformity are available on the Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
CZ
IT
The regulations of the country where the prod-
ucts are operated must always be observed
Prior to operating the products, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to
the national authorities can be found via the
following Internet address:
www cept org
tECC
tTopics
tOther spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
tEFIS and National Frequency Tables

3 Operation

The UF-20R / 5 and the UF-20S / 5 can be placed
on a table as desired However, the UF-20R /5
can also be installed into a rack (482 mm / 19")
In the rack, it requires one rack space (1 RS =
44 45 mm)
The receiver UF-20R / 5 is equipped with two
receiver sections; connection and operation of
these sections are identical Therefore, the de-
scription below refers to one receiver section
only

3.1 Connections

1) Insert the two antennas (2) provided into the
antenna jacks (17) and put them in a vertical
position
Hints:
1 To increase the range and the interference re-
sistance, the antenna amplifiers UB-900I can be
inserted The amplifiers are supplied with power
via the antenna jacks of the receiver (chapter 3 4)
2 On the receiver UF-20R /5, the set of antenna
jacks RTF-UF20 can be used to fix the antennas at
the front of the receiver: Insert the jacks through
EL FI FR
LT MT PL