Publicidad
Idiomas disponibles
Idiomas disponibles
•
Push [
] to display the selection menu for the different operating modes.
•
Use the up/down button to select the operating mode BT and push [OK].
•
Switch your BT device to which you want to connect the radio on and activate the pairing mode here. The device
scans for BT devices in the reception range.
•
When the radio is found, your BT device shows its name Audizio Livorno-XXXX (the XXXX is an identification code for
your radio unit).
•
Select the radio on your BT device.
•
Start playback on your BT device.
•
Playback now takes place using the radio.
• Choose Alarm from the home screen or press the [ ] button on the remote control.
• Select either Alarm 1 or Alarm 2, choose Turn on to activate the alarm.
• Follow the alarm wizard instructions to set the alarm.
• The wizard will guide you through the settings below:
Time - Set the time for the alarm.
Sound - You can choose Wake to Tone, My Favourite, Wake to FM Radio or Wake to DAB Radio as the alarm source.
Note:
Wake to FM or Wake to DAB Radio - only the preset stations can be used for the radio alarm (if the preset scan has
been completed).
Wake to My Favourite - Preset your favorite station before setting this as the alarm source.
Repeat - You can schedule the alarm as you desire: Everyday, Once or multiple days.
Alarm Volume - Adjust the volume of the alarm as you like by using the directional buttons on the remote.
Alarm Duration - Set the duration of the alarm from the preset options ranging from 30 to 180 minutes. The radio
will be turned to standby when the selected duration of time is due.
• After the above settings are completed, press the [◄] button to exit and make sure the alarm is turned on. You will see that
the alarm icon has appeared on the display when activated correctly.
You can set the timer to let the radio go into standby mode after the selected time elapsed in the range of 15 minutes to 180
minutes. Press [
] on the remote control to set the timer. You will see the icon appear on the display when the timer is set.
Here you will find the complete settings / options available to configure your own radio. On the Main Menu, navigate to
Configuration setting. Press [OK] and you will see a list of options available.
Network
•
Wireless Network
o Add wireless network
Scan & select - It will scan out a list of wireless networks around.
WPS button - Choose this option to connect your Wi-Fi router via WPS if the router has a WPS button.
o Remove wireless network
If you have already set up a network and want to remove it, choose this option.
Note: Always bring the tuner within 2 meters of the Wi-Fi router for setup.
o AP:[]
If you have added more than one network and want to switch to another one, select this option to change.
o Signal
Shows the strength of the wireless signal of the router as received by the tuner. Usually signal levels lower than -
70dBm is at weaker level and if reception is affected, you may need to optimize the router location and/or check
for any problems of the router itself.
o IP
The IP is set to Dynamic by default. Select Fixed IP according to your network condition.
o DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS according to your network condition.
•
Network Options
Always on: The WLAN function remains switched on (faster access when switching from other modes of radio).
Auto off in 15/30s: The WLAN function shuts down after 15/30 seconds when not in use to save energy.
11
Publicidad
