Petsafe PDT19-14596 Manual De Funcionamiento página 12

6. Trim the collar as follows: (3D)
a. Mark the desired length of the collar with a pen.
Allow for growth if your dog is young or grows a
thick winter coat.
b. Remove the Receiver Collar from your dog and cut
off excess.
c. Before placing the Receiver Collar back onto your
dog, seal the edge of the cut collar by applying a fl ame along the frayed edge.
The Receiver Collar should not be worn for more than 12 hours out of every
24-hour period. Leaving the collar on too long could lead to skin irritation.
Please refer to page 3 for additional information.
To Re-Thread the Collar
Ridges
Ensure a Proper Spray Pattern
For the PetSafe 275 m Deluxe Remote Spray Trainer to perform properly, the nozzle must be
®
positioned correctly and there must be a clear path from the Spray Nozzle to your dog's
snout. Follow these steps:
1. Make sure the PetSafe
Spray Nozzle is angled out and pointing up towards the dog's snout.
2. For long-haired dogs, it may be necessary to trim the neck hairs
along the path of the spray. It is important that the spray reaches the
dog's snout to be effective.
Do not shave the pet's neck as this may increase the risk of skin irritation.
12
Slide Buckle
logo on the front of the unit is upright and the
®
www.petsafe.net
3D
The slide buckle prevents the collar from
becoming loose around your pet's neck.
The ridges must be facing up; the collar will
slip if it is not properly threaded.