Before Cutting - Hitachi Koki C 10FS Manual De Instrucciones

Tronzadora radial abatible
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

11. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for deflection to confirm that the blade is not noticeably
unstable; otherwise vibrations might occur and cause an accident.

BEFORE CUTTING

1. Cutting a groove on the guard
Fence (B)
Workpiece
Vise Assembly
Guard
Fig. 8
2. Positioning the table insert
6mm
Machine
Workpiece
Screw
[Right angle cutting]
Fig. 9-a
Table inserts are installed on the turntable. When shipping the tool from the factory, the table inserts
are so fixed that the saw blade does not contact them. The burr of the bottom surface of the workpiece
is remarkably reduced, if the table insert is fixed so that the gap between the side surface of the table
insert and the saw blade will be minimum. Before using the tool, eliminate this gap in accordance with
the following procedure.
(1) Right angle cutting
Loosen the three 6mm machine screws, then secure the left side table insert and temporarily tighten
the 6mm machine screws of both ends. Then fix a workpiece (about 7-7/8" (200mm) wide) with the
vise assembly and cut it off. After aligning the cutting surface with the edge of the table insert,
securely tighten the 6mm machine screws of both ends. Remove the workpiece and securely tighten
the 6mm center machine screw. Adjust the right hand table insert in the same way.
(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in Fig. 9 following the same procedure for right angle
cutting.
CAUTION:
After adjusting the table insert for right angle cutting, the table insert will be cut to
some extent if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust the table insert for bevel angle cut-
ting.
Holder (A) has a guard (see Fig. 8) into which a groove must be cut.
Loosen the 8mm knob bolt to retract the guard slightly. After placing
8mm Knob Bolt
a suitable wooden piece to sit on the fence and the table surfaces,
fix it with the vise assembly.
After the switch has been turned on and the saw blade has reached
Holder
maximum speed, slowly lower the handle to cut a groove on the
(A)
guard.
CAUTION:
Fence (A)
6mm
Machine
Screw
Saw Blade
Table insert
[Left bevel angle cutting]
Do not cut the groove too quickly; otherwise the
guard might become damaged.
Workpiece
Saw Blade
Table insert
Table insert
Fig. 9-b
6mm
Workpiece
Machine
Screw
Saw Blade
[Right bevel angle cutting]
Fig. 9-c
English
13

Publicidad

Tabla de contenido
loading

Tabla de contenido