Practical Applications - Hitachi Koki C 10FS Manual De Instrucciones

7. Stopper for precision cutting ... (Stopper is optional accessory)
Workpiece
6mm Knob Bolt
Fig. 13
8. Using an ink line
Saw Blade
Groove
Guard
Workpiece
Fig. 14
8mm Knob Bolt
Move the
Guard
Backward
Fence (B)
Fig. 15

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 16).
Line
The stopper facilitates continuous precision cutting in lengths of
Stopper
10-7/16" to 16-15/16" (265mm to 430mm).
Holder To install the stopper, attach it to the holder with the 6mm knob
bolt as shown in Fig. 13.
(1) Right angle cutting
Loosen the 8mm knob bolt and contact the tip of the guard
with the workpiece.
Aligning the ink line on the workpiece with the groove of the
guard, the workpiece is cut on the ink line (Fig. 14).
8mm
Knob Bolt
Marking
(pre-marked)
(2) Miter cutting and compound cutting
(Miter cutting + bevel cutting)
Safety Upon lowering the motor section, the safety cover is raised and
Cover
the saw blade appears.
Align the ink line with the saw blade (Fig. 15).
Guard
CAUTION:
Marking
(pre-marekd)
Warning Sign
Fig. 16
In some arrangements when the turntable is
rotated, the guard projects from the fence sur-
face. Loosen the 8mm knob bolt and push the
guard to the retracted position. Never lift the
safety cover while the saw blade is rotating.
Warning Sign
English
Line
15