Tabla de contenido
Publicidad
ACCESSORIES
Supplied
52mm snap-on front lens cap
Rear lens cap LF-1
Optional
Slip-on lens hood HK-11
52mm screw-in filters
Soft lens case No. 62
(for lens without food)
Soft lens case No. 63
(for lens with food)
Hard lens case CL-33S
Teleconverter TC-201
Teleconverter TC-14A
LENS CARE
• Although you should always keep the lens surfaces clean,
rough cleaning must be avoided. Wipe with a soft, clean
cotton cloth moistened with alcohol to remove grease or
fingerprints from the lens surfaces.
If you use ether in cleaning the lens, a smudge sometimes
appears on the surface of a multi-coated lens. If this
happens, wipe it again with a cotton cloth moistened with
alcohol.
• To protect the lens surface from dirt or damage, the use
of an L37C filter is recommended at all times. The lens
hood also helps to protect the lens.
• Keep the lens cap in place whenever the lens is not in use.
• Attach both the front and rear caps when the lens is
stored separately.
• To ensure proper fit of the lens when stored in the leather
lens case, set the lens' focusing ring to the infinity (°»)
setting.
• Be careful not to get the lens wet or drop it in water. Water
on the lens may cause malfunction.
• If you will not use the lens for a long time, protect it from
rust and mold by storing it in a cool, dry place. Also, do not
store in direct sunlight, and keep it away from naphthalene
or camphor.
13
Publicidad
Tabla de contenido
