Descargar Imprimir esta página

EAS ELECTRIC EMD120W Manual De Instrucciones página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Starting a Washing Programme
Wash cycle table
Cycle Selection
Program
Information
Pre-wash
For the heaviest soiled loads,
Main wash(60 )
such as pots, pans, casserole
Rinse1
dishes and dishes that have
Rinse2
Intensive
been sitting with dried food
Hot rinse
on them for a while.
Drying
Eco
Pre-wash
For normally soiled loads,
Main wash(44 )
such as pots, plates, glasses
(*En50242)
(Standard
Hot rinse
and lightly soiled pans.
Programme)
Drying
standard daily cycle.
Light wash cycle to be used
Pre-wash
for more delicate items which
Main wash(45 )
are sensitive to high
Rinse
temperatures.(Run cycle
Hot rinse
Light
immediately after use)
Drying
Main wash(40 )
For lightly soiled loads, such
Rinse
as plates, glasses, bowls and
Hot rinse
lightly soiled pans.
Drying
Crystal
A shorter wash for lightly
Main wash(40 )
soiled loads that do not
Hot rinse
Rapid
need drying.
To rinse dishes that you
Pre-wash
plan to wash later that day
Pre-Rinse
EN
50242:this program is the test cycle.
The information for comparability test in accordance with EN 50242,as follows:
-
Capacity:12 settings
- Position of upper basket :Low position
- Rinse aid setting:6 (or 4 for four setting dispenser)
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
2. Insert the plug into the socket. The power supply is 220-240V AC 50 HZ, the specification of the
socket is 12 A 250 VAC.50 HZ.
Make sure that the water supply is turned on to full pressure. Close the door, press the ON/OFF
button, rotate the program selector to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table".)
With a little force to ensure the door is properly closed.
14
Running
Description
Detergent
Energy
Time
3in1
of Cycle
(kWh)
Pre/main
(min)
/
5/25
180
1.300
/
180
1.170
/
5/25
237
0.900
/
237
0.900
/
5/20
0.850
137
/
0.700
137
/
124
5/20
0.800
/
15
39
0.500
/
/
11
0.010
NOTE:
A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing ON/OFF button.
Select a programme
Choose your programme according to the type of load and how dirty it is.
Water
(L)
The different programmes and their uses are described in the programme chart later on in this
booklet. Use the programme selector to select the expected programme .
16
Change the Programme.
16
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
11
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
1 Press the "ON/OFF" button to cancel the programme.
11
2 Turn on it again and rotate the programme selector to the expected cycle setting ( see the section
14
entitled "Starting a wash cycle. . .").
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
14
appears E1. When you close the door, the machine will keep on working after 10 seconds.
Forget to Add Dish
9
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
7
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
4
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "--" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
V.1
V.1
15

Publicidad

loading

Este manual también es adecuado para:

Emd120x