Publicidad
Idiomas disponibles
Idiomas disponibles
Safety
Electrical installation
Direct Connection
• The appliance must be connected directly to the mains using
an omnipolar circuit breaker with a minimum opening of 3 mm
between the contacts.
• The installer must ensure that the correct electrical connection
has been made and that it complies with the wiring diagram.
• The cable must not be bent or compressed.
• Regularly check the power cord for damage. If the supply cord
becomes damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a
hazard.
WARNING: This is a Class I appliance and MUST be earthed.
• The appliance is supplied with a 3-core mains cable and must
be connected to the electricity supply via a double pole switch
having a 3 mm minimum contact gap on each connector.
• This appliance should be connected directly to the consumer
unit with a 16 Amp Residual Current Device (RCD) protecting its
circuit.
The wires in the mains lead are coloured in accordance with the
following code:
Brown = L - Live
Blue = N - Neutral
Green and Yellow =
To avoid the risks that are always present when you use an
electrical appliance it is important that this appliance is installed
correctly and that you read the safety instructions carefully to
avoid misuse and hazards. Please keep this instruction booklet
for future reference and pass it on to any future owners. After
unpacking the appliance please check that it is not damaged. If in
doubt, do not use the appliance but contact Customer Services
-see end of Care & Maintenance section for details.
- Earth
10
Publicidad
