Publicidad
Idiomas disponibles
Idiomas disponibles
The minimum conductor size is 1 mm
the maximum length is 30 m.
Unpacking
Fitting the warning label (fig. B)
The safety warnings on the label shown on the tool
must be formulated in the language of the user.
For that purpose, a separate sheet of self-adhesive
labels has been supplied with the tool.
• Check that the safety warnings on the label have
been formulated in your language.
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 3R LASER PRODUCT
• If the warnings are in a foreign language,
proceed as follows:
– Draw the required label from the sheet.
– Carefully place the label over the foreign
language.
– Press the label in place.
Assembly and adjustment
• Prior to assembly and adjustment,
always remove the battery pack.
• Always switch off the tool before
inserting or removing the battery pack.
Use only D
E
chargers.
Battery pack (fig. A & C1 - C4)
Charging the battery pack (fig. A)
When charging the battery pack for the first time, or
after prolonged storage, it will only accept an 80%
charge. After several charge and discharge cycles,
the battery pack will attain full capacity.
Always check the mains prior to charging the battery
pack. If the mains is functioning but the battery pack
does not charge, take your charger to an authorised
D
WALT repair agent. Whilst charging, the charger
E
and the battery pack may become warm to touch.
This is a normal condition and does not indicate
a problem.
All manuals and user guides at all-guides.com
2
;
WALT battery packs and
Do not charge the battery pack at
ambient temperatures < 4 °C or > 40 °C.
Recommended charging temperature:
approx. 24 °C.
• To charge the battery pack (4), insert it into the
charger (6) as shown and plug in the charger.
Be sure that the battery pack is fully seated in the
charger. The red charging indicator (7) will blink.
After approx. 1 hour, it will stop blinking and
remain on. The battery pack is now fully charged
and the charger automatically switches to
equalise mode. After approx. 4 hours, it will
switch to maintenance charge mode. The battery
pack can be removed at any time or left in the
connected charger indefinitely.
• The red charging indicator flashes rapidly to
indicate a charging problem. Reinsert the battery
pack or try a new one. If the new pack also
refuses to charge, have your charger tested by
an authorized D
WALT repair agent.
E
• When plugged into power sources such as
generators or sources that convert DC to AC, the
red charging indicator may blink twice, switch off
and repeat. This indicates a temporary problem
of the power source. The charger will automatically
switch back to normal operation.
Inserting and removing the battery pack (fig. C1)
• Insert the battery pack (4) into the tool until it
clicks in place.
• To remove the battery pack, press the two release
buttons (5) simultaneously and pull the pack out
of the tool.
Battery cap (fig. C2)
A protective cap is supplied to cover the contacts of
a detached battery pack. Without the protective cap
in place, loose metal objects could short circuit the
contacts, causing a fire hazard and damaging the
battery pack.
• Take off the protective cap (4) before placing the
battery pack (12) in the charger or tool.
• Place the protective cap over the contacts
immediately after removing the battery pack from
the charger or tool.
E N G L I S H
31
Publicidad
