Lockncharge iQ 16 Cart Manual De Instrucciones página 6

iQ 16 Cart™
Move the iQ 16 Cart to where you intend to store and secure it.
Note: It is best if the Floor Plate is as close as possible to a wall to reduce the hazard or tripping and injury.
Attach the end of the chain to the steel loop with the padlock and position the plate end in the desired
position on the floor.
Note: If mounting on carpet, you will need to cut out the carpet from the area where the floor plate attaches,
otherwise the carpet will wrap around the drill when drilling.
Mark the centre of each of the
3 holes using the floor plate as a
guide.
Insert the anchor bolts with the
nuts attached into the holes
through the floor plate. Using
the 13mm spanner, progressively
tighten down each of these anchor
nuts so that all three bolts are firmly
anchored into the concrete.
Now undo each of the three nuts and in
their place thread on the three silver shear-
nuts. Ensure that the 'cone' is down and the
hexagonal nut is up. Using the 17mm spanner,
tighten down the three shear-nuts until the
hexagonal 'head' shears off, leaving just the
cone 'base'.
Attach the security chain through the
steel loop under the side of the trolley
using the padlock.
Note: there is a lock-down loop on both
sides of the iQ 16 Cart.
Drill a 10mm hole through each of
the 3 marked centres to a depth
of 50mm.