Set Check Weighing; Parameters & Calibrate; Enter Setting Mode; Calibrate - Baxtran BS-TRI Serie Manual De Usuario

6.6 SET CHECK WEIGHING

Beep mode see parameter F7 BEP
• Check mode 0 : No beep sound in the limits. Function turned off.
• Check mode 1 : When the weight is between the limits. And beeper will be sounded.
• Check mode 2 : When the weight is out of the limits, the beeper will be sounded.
7. PARAMETERS & CALIBRATE

7.1 ENTER SETTING MODE

The scale has 11 parameters that can be set by the user plus a method of entering the calibration section.
To set parameters or calibration, first turn off the weighing scale, then turn on again and keep
Countdown till Display show F0 CAL. Press back menu in the parameter to return to the weighing mode.
Parameters with an asterisk * are blocked by the calibration button. To access them you have to break the seal, thus losing
the verification.

7.2 CALIBRATE*

After enter setting mode, the display will show "F0 CAL". Then press the calibration switch to enter calibration.
Press key, display shows "UnLD", empty the platter, after STABLE indicator on. Press
shows the calibrate weight, you can press
calibrate weight on, after STABLE indicator on, press
mode , the calbration is finished.

7.3 CHANGE RESOLUTION*

After enter setting mode, the display shows "F0 CAL", press
enter, press

7.4 CHECK INTERNAL COUNTS

After enter setting mode, display shows "F0 CAL", press
enter, display shows internal counts, press

7.5 SET THE LOCAL GRAVITY*

After enter setting mode, display shows "F0 CAL", press
enter, Press

7.6 SET AUTO POWER OFF

After enter setting mode, display shows "F0 CAL", press
enter, press
6
key to select increment, press
key to change the value, press
key select the auto power off time (0, 3, 5,15,minutes), press
key to select calibrate weight, after you select, press
key to sure, display shows "PASS", then come back to setting
key, display shows "F1 res", press
key to sure.
key until display shows "F2 INP", press
key to return setting mode.
key until display shows "F3 grv", press
key to shift location. press
key until display shows "F4 OFF", press
USER'S MANUAL BS-TRI
key until display show "F0 CAL".
pressed during initial
key again, display
key,put the
key to return setting mode.
key to confirm.
EN
key to
key to
key to
key to