Grundig CMS 5000 Manual Del Usuario página 31

MAIN­OPERATION­
FM­Radio
FM radio mode receives analogue radio from
the FM band and displays RDS (Radio Data
System) information about the station and where
broadcast.
The first time you select FM radio mode, or if the
station list is empty, the device will run auto scan
and save the stations to the preset list.
To find a station, press »OK/SCAN«
The frequency display starts to run up as the
device scans the FM band. Alternatively, you can
scan up or down by turning the navigate knob.
Settings
ATS: Run the auto scan function once
7
Scan settings By default, FM scans stop at any
7
available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations.
To change the scan settings to stop only at sta-
tions with good signal strength, select Yes after
choosing Strong station only ?
A udio settings All stereo stations are repro-
7
duced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To
play weak stations in mono, select FM weak
reception: Listen in mono only and then YES.
CD
Press » « to open the CD compartment. Put in the
disc with its label facing upwards.
Press » « to close the CD compartment. The disc
is read and played.
­--------------------------------------------------------------------------------------------------
„TO00"means the track number.
„F00" means the folder number, it displays if you
have inserted CD-R or CD-RW disc which con-
tains the music tracks in different folders.
Press »FOLDER­
seek the folder.
Besides general playback control, you may
do CD track programming as follows: Stop
the playback first if any track is playing. Press
»PRESET/BTPAIR« to program. Set the first
programming track, use »
track. Press »OK/SCAN« to confirm and set the
next programming track. Repeat the steps. When
programming is completed, press » «
to start playing the programmed track(s).
USB
In USB mode, plug in the a USB drive to play.
„TO00"means the track number.
„F00" means the folder number, it displays
if the plugged USB drive contains the music
tracks in different folders. »FOLDER­DOWN« /
»FOLDER­UP« to seek the folder.
Besides general playback control, you may do
USB track programming as follows:
Stop the playback first if any track is playing.
Press »PRESET/BTPAIR« to program. Set the
first programming track, use »
to seek the track. Press »OK/SCAN« to confirm
and set the next programming track. Repeat the
steps. When programming is completed, press
» « to start playing the programmed track(s).
DOWN« / »FOLDER­
« » « or to seek the
5 6
« or »
ENGLISH
UP« to
«
31­ ­