SYSTEMSETTINGS
PBCWlansetup:
Push Button Configuration, it is to connect the AP
that supports WPS (Wi-Fi Protected Setup).
Viewsettings:
View the information of current connected net-
work: Active connection, MAC address, Wlan
region, DHCP, SSID, IP address, Subnet mask,
Gateway address, Primary DNS and Secondary
DNS.
Manualsettings:
Enable or disable DHCP (Dynamic Host
Configuration Protocol). Input the SSID, WEP /
WPA key and/or other configuration.
Networkprofile:
The device remembers the last four wireless net-
works it has connected to, and automatically tries
to connect to whichever one of them it can find.
From here you can see the list of registered net-
works. You can delete unwanted networks. Clear
network settings: Select "YES" to clear all the
current network settings. Select "NO" to cancel.
Keepnetworkconnected:
If you choose to keep network connected, the
WiFi will not disconnect even you are in standby
mode or non-network mode.
Time/Date
Set the time manually or auto update, time
format, time zone and daylight. Details can be
referred to Setting date and time under Section
First-time setup.
Language
Change it as your preference. Available langu-
ages: English, Danish, Dutch, Finnish, French,
German, Italian, Norwegian, Polish, Portuguese,
Spanish, Swedish, Turkish.
FactoryReset
Resetting all user settings to default values, so that
time and date, network configuration and presets
are lost. However, current software version of the
radio is maintained
----------------------------------------------------------------------------------------------------
SoftwareUpdate
Auto-check setting: This option automatically
checks for new updates from time to time.
Automatic updating is enabled by default. Check
now: Search for available updates immediate-
ly. You will be asked if you want to go ahead
with download and installation of an update.
After a software upgrade, all user settings are
maintained. NOTE: Before starting a software
upgrade, ensure that the radio is plugged into
a stable main power connection. Disconnecting
power during an upgrade may permanently
damage the unit.
SetupWizard
With this function, you can start the setup wizard
at any time. Any parameters or stations entered
already are not deleted. For more information,
please read the Section First-time setup.
Info
View the firmware version and the radio ID.
PrivacyPolicy
View the information of Privacy Policy.
Backlight
You may change the power - on backlight level
to High, Medium or Low. And adjust the timeout
duration which the radio turns to standby back-
light level when it has not been controlled. Press
» DIMMER « to change the brightness of the
backlight.
ENGLISH
33