Publicidad
Idiomas disponibles
Idiomas disponibles
If this Craftsman Professional product fails due to a defect in material or workmanship within three years from the date of purchase, return it to any Sears store,
Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only one year if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds.
• Edging
• Decorative trimming around trees, fences, etc.
Cutting Head
INSTALL AND ADJUST THE D-
HANDLE
1.
Place D-handle over the
shaft housing and onto the
bottom clamp (Fig. 1). Place
it a minimum of 6 inches
(15.24 cm) from the end of
the shaft grip.
2.
Start screws with a large
Flat-head or T-25 Torx
screwdriver. Do not tighten
until making the necessary
handle adjustment.
3.
While holding the unit in the operating position (Fig. 9), move the D-
handle to the location that provides the best grip.
WARRANTY STATEMENT
CRAFTSMAN PROFESSIONAL FULL WARRANTY
Sears, Roebuck and Co., Hoffman Estates, IL 60179
D-Handle
Attachment
Shaft
Cutting Head Shield
Line Cutting
Blade
ASSEMBLY INSTRUCTIONS
Shaft Grip
Screws (4)
Minimum 6 in.
(15.24 cm)
Bottom
Clamp
Fig. 1
KNOW YOUR UNIT
Shaft Grip
Convertable™
Coupler
On/Off Control
Throttle
Control
4.
Tighten the clamp screws evenly, until the D-handle is secure.
INSTALL THE SHOULDER SUPPORT
1.
Put the shoulder support on
using the clip. (Fig. 2).
2.
Adjust by lifting slightly on
the rear of the lower clip then
push or pull the loose end of
D-Handle
the strap length to fit the
operator's size and comfort.
(Fig. 3).
3.
Attach the shoulder clip to
the unit. (Fig. 4)
4
Muffler
Spark Plug
Starter Rope
Grip
Fuel Cap
Air Filter
Choke Lever
Primer Bulb
Cover
Fig. 2
Publicidad
