Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 13

Running a Program With the Speed Slider
1. Be sure the Audio mode is disengaged, that is,
the Audio LED goes out.
2. Select your program as described above.
3. Move the Speed slider to the SHOW MODE
position (the bottom), then tap the Flash button
(25-48) while pressing and holding down the
Rec Speed button, the corresponding program
will not run with the Standard beat any longer.
4. Now you may move the Speed Slider to select
your desired speed.
Note: The step 3 is not necessary if the selected pro-
gram is not recorded with the Standard Beat.
Running a Program With the Standard Beat
1. Be sure the Audio is disengaged. Tap the Mode
Select button to select CHNS ◀▶ SCENE mode.
2. Tap the Park button to select Mix Chase mode,
the LED lights indicating this selection.
3. Select your program as described above.
4. Move the Speed slider until the Segment Dis-
play reads your desired value. You may tap the
Tap Sync button twice to define your beat time.
5. While pressing and holding down the Rec
Speed button, tap the Flash button (25-48) that
stores the program.
6. The program will then run with the set time or
beat when engaged.
7. Repeat steps 4 and 5 to set a new beat time.
English version | Tecshow Navigator 48 MKII
P. 13