Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 8

5. Repeat step 3 and step 4 until all desired steps
have been programmed into memory. You may
program up to 1000 steps into memory.
6. Select a chase bank or scene master to store
your program. Tap the Page button to select a
page to store your scenes.
7. Press a Flash button between 25-48 while
holding down the Record button. All LED will
flash indicating the scenes have been pro-
grammed into memory.
8. You can continue programming or exit. To exit
Program mode, tap the Exit button while hold-
ing down the Record button, the Record LED
should go out.
P. 8
Tecshow Navigator 48 MKII | English version
Example: Program a 16 steps chase with channel 1-32
at full in sequence into Flash button 25 of Page 1.
1. Record enable.
2. Push Master A & B to maximum position and Fade
slider to top.
3. Tap the Mode Select button to select 1-48 Single
mode.
4. Push Channel slider 1 to the top position, its LED
light at full intensity.
5. Tap the Record button to program this step into
memory.
6. Repeat steps 4 and 5 until you've programmed
Channel sliders 1-32.
7. Tap the Page button causing Page 1 LED lights.
8. Tap the Flash button 25 while holding down
the Record button, all LEDs will flash indicating
you've programmed the chase into memory.
Editing
Edit Enable
1. Record enable.
2. Use the Page button to select the page the
program you wish to edit is on.
3. Tap the Mode Select button to select
CHNS ◀▶ SCENES.