Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

value: Press and hold the Shift Button. While
holding down the Shift button press the % or
0-255 Button to switch between percentage
and absolute values.
3. If the Segment Display reads, for example,
"076", it means a percentage value 76%. If the
Segment Display reads "076.", it means the DMX
value 76.
Blind and Home
1. Blind function takes channels temporally out
from a chase, when the chase is running, and
gives you manual control over the channel.
2. Press and hold the Blind Button and tap the
relative Flash Button you want to temporarily
take out of the chase.
3. To return to normal chase again press and hold
the Home Button and push the Flash Button
you want to return to normal chase.
Park
1. In CHNS ◀▶ SCENES Mode, press down the
button you can change the chasing mode of
programs between Single Mode and Mix Mode.
2. In Double Preset Mode, pressing down this
button is equal to pushing Master Slider B to
the top.
3. In Single Preset Mode, this button could tem-
porally record current output, with Master
Slider B to adjust.
Add and Kill
The ADD/KILL Button changes the mode of the flash
buttons. Normally the flash buttons are in Add
mode, whereas pressing any flash button will not
kill other scenes, allowing multiple scenes to be on
at a time. The Kill mode is activated by pressing
the Add/Kill button and illuminating the LED above
it. Pressing any flash button will kill other active
SCENE or Program.
Design and product specifications are subject to change without prior notice.
P. 18
Tecshow Navigator 48 MKII |
English version
In Kill Mode, the killed program does not stop run-
ning but can not output.
Double Preset
1. Press Mode Select Button to enter A Double
Preset Mode.
2. In this mode, Channel Sliders 1-24 and channel
sliders 25-48 both control Channel 1-24.
3. Master A controls channel Slider 1-24 while Mas-
ter B controls Channel Sliders 25-48. 4. In this
Mode, no scene could be recorded.
Example
1. Enter the Double Preset Mode.
2. Push Channel Sliders 1 to 6 to the top and move
Channel Sliders 19 to 24 to the maximum.
3. Move Master A and B to the same level and
push them to the same direction, you will get a
scene.
Attention!
1. To retain your programs from loss, this unit
must be powered not less than two hour every
month.
2. The Segment Display shows "LOP" if the voltage
is too low.

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido