Single Mode - Ampro TECSHOW NAVIGATOR 48 MKII Manual De Usuario

6. BRIEF OF MAIN FUNCTIONS
Reverse the direction of the scene
1. Reverse the direction of all the scenes: Press
the ALL REV Button, all the scenes should
change their directions.
2. Reverse the chasing direction of all the pro-
grams with speed control. Press the Chase Rev
Button.
3. Reverse the chasing direction of all the pro-
grams with standard beat: Press the Beat Rev
Button.
4. Revers chasing direction of any program:
Press and hold down the Rec One Button, then
press down the Flash Button corresponding to
your desired program and release together.
Fade Time
1. The amount of time it will take for the dimmer
to go from zero output to maximum output,
and vice verse.
2. Fade time is adjusted through the Fade Time
Slider, which varies from instant to 10 minutes.
Tap Sync Button
1. The Tap Sync button is used to set and syn-
chronize the chase rate (the rate at which all
scenes will sequence) by taping the button
several times. The chase rate will synchronize
to the time of the last two taps. The LED above
the Step Button will flash at the new chase rate.
The chase rate may be set anytime whether or
not a program is running.
2. Tap Sync will override any previous setting
of the speed slider control until the slider is
moved again.
3. Use of Tap Sync in setting a standard beat is the
same with speed control slider.
Master Slider
Master Slider control provides proportional lev-
el control over all channels and scenes with the
exception of the Flash Buttons. For example:
Whenever the Master slider control is at minimum
all stage outputs will be at zero except for any
resulting from a Flash Button or FULL ON Button. If
the Master is at 50%, all outputs will be at only 50%
of the setting of current channel or scenes except
for any resulting from a Flash Button or FULL ON
Button. If the Master is at full all outputs will follow
the unit setting.
Master A always controls outputs of channels.
Master B controls the program or a scene except in
Double Preset Mode.

Single Mode

1. All programs will run in sequential order start-
ing in the order of program number.
2. The Segment Display will read the running pro-
gram number.
3. All programs will be controlled by the same
Speed Slider .
4. Press the MODE SELECT BUTTON and select "
CHNS ◀▶ SCENES".
5. Press the PARK BUTTON to select SINGLE
CHASE MODE. A red LED will indicate this selec-
tion.
Mix Mode
1. Will run all programs synchronously.
2. All programs can be controlled by the same
SLIDER SPEED, or each programs speed may be
controlled individually. (See Speed Setting ).
3. Press the MODE SELECT BUTTON and select
"CHNS ◀▶ SCENES".
4. Press the PARK BUTTON to select MIX CHASE
MODE. A yellow LED will indicate this selection.
Dimmer Display
1. The 3-Digit Segment Display is used to display
intensity percentage or absolute DMX value.
2. To change between percentage and absolute
English version | Tecshow Navigator 48 MKII
P. 17