Craftsman 247.29931 Manual Del Operador página 10

Muffler
air filter
Pull starter Handle
throttle
Now that you have set up your tiller for operation, get aquainted with its
controls and features. These are described on the next two pages and
illustrated on this page. This knowledge will allow you to use your new
equipment to its fullest potential.
recoil STarTer hanDle
This handle is used to start the engine. See Figure 5.
ThroTTle conTrol
The throttle control is located on the front of the engine. It regulates the
spread of the engine and will shut off the engine when moved into the
STOP position. See Figure 5.
Craftsman Tillers conform to the safety standard of the American National Standards Institute (ANSI).
OPERATION
reverse Handle
fuel Cap
oil fill Cap
& Dipstick
oil Drain
Figure 5
The operation of any tiller can result in foreign objects being thrown
into the eyes, which can damage your eyes severely. Always wear the
safety glasses provided with this unit or eye shields before tilling and
while performing any adjustments or repairs.
choke conTrol
The choke control is activated by moving the lever to the CHOKE
position. Activating the choke control closes the choke plate on the
carburetor and aids in starting the engine.
Meets anSi Safety Standards
10
forward Clutch Bail
& tine Engagement
Depth regulator
Handle Height
adjustment
side shield
tines
wheel Drive Pin
Warning
rear tine shield