Publicidad
Idiomas disponibles
Idiomas disponibles
General Safety Instructions
Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing.
•
The appliance is designed exclusively for private use
and for the envisaged purpose. This appliance is not fi t
for commercial use. Do not use it outdoors (except if it is
designed to be used outdoors). Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately. Do
not put it in water.
•
When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull on the
plug, not the cable) if the appliance is not being used and
remove the attached accessories.
•
Do not operate the machine without supervision. If you
should leave the workplace, always switch the machine off
or remove the plug from the socket (pull the plug itself, not
the lead).
•
Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
•
Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
•
Use only original spare parts.
•
Pay careful attention to the following "Special Safety Instruc-
tions".
Children
•
In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
•
To protect children from the dangers posed by electrical
appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
Special Safety Instructions
•
Fill the water tank only with cold water!
•
Never open the lid of the water tank while the coffee is
percolating. Otherwise this may result in severe burns.
•
The warming plate becomes hot! Danger of burning!
Putting the device into operation
•
Remove all the packaging and transport protections from the
device. Wipe all the parts with a moist cloth to remove all the
dust that may have deposited on and in the device during
transport. Then mount the device again by proceeding in the
opposite order.
•
Carry out 2 or 3 cycles with cold water only to clean the
device before brewing the fi rst cup of coffee.
16
05-KA 1331 CB 16
Electrical connection
•
Insert the plug in a duly installed 230 V/50 Hz protective
contact socket. The details can be found on the appliance's
nameplate.
•
Make sure that the appliance is switched off. The control
lamp on the front of the coffee machine is off.
Operating
1. Pull the lid of the water tank forwards. Fill the machine to the
level corresponding to the number of cups required with cold
water.
2. Bend the lower fold of the paper fi lter (size 1x4), place it into
the fi lter funnel and fi ll it with coffee powder (approx.
1 teaspoon for 2 cups).
3. Close the water tank lid.
4. Place the pot evenly on the base. Please ensure that the lid
is on the pot.
5. Switch on the appliance. The control lamp on the front of the
coffee machine lights up.
6. The brewing lasts about 10 to 15 minutes.
7. Your appliance is provided with a drip stop. By removing the
pot, before the water runs through the fi lter completely, it
avoids that the coffee drips on the base. If there is still water
in the tank or fi lter, make sure that the pot is placed back
under the fi lter to avoid overfl owing.
8. When the coffee stops fl owing into the fi lter, you can remove
the pot.
9. Switch off the appliance. The control lamp goes out.
Tip: The fi lter holder can be removed from the machine by its
handle. This makes it easier to dispose of the old coffee fi lter,
for example.
AROMA CONTROL
Aroma selection switch
Turn the knob under the round scale. Select a setting between
„LIGHT" (weak coffee) and „STRONG" (strong coffee) according
to taste. The setting can be read off on the round scale.
De-scaling
•
De-scaling is necessary when the brewing time increases
substantially.
•
Use only commercially available citrus acid-based de-scaler.
Follow the recommended instructions for use.
Important!
•
After descaling you should boil fresh water without coffee in
the machine approximately 3-4 times. This will remove any
residues from the descaling process.
•
Do not use this water for consumption.
Cleaning
•
Before cleaning the machine you should always remove the
mains lead and wait until the machine has cooled down.
•
The machine should only be cleaned with a slightly damp
cloth.
•
Do not use any strong detergents or solvents for cleaning.
26.06.2006, 14:38:22 Uhr
Publicidad
