Publicidad
Idiomas disponibles
Idiomas disponibles
2. Rointe towel rails installation
2.1. Mounting instructions
Inside the packaging you will find a fixing kit. Please find the instructions below:
Inside the box/packaging you will find a mounting kit:
1. Choose the right part of the wall.
2. Place the mounting stencil on the wall, marking the places for the holes.
3. Remove the stencil and make the holes in the wall.
4. Insert the rawl plugs in the holes made.
5. Screw the four metallic fasteners to the wall with the 6.3 x 50 mm screw.
6. Screw the four metallic cylinders to the product (see Figure 1).
7. Insert what you have assembled in Section 6 into the metallic fastener and fix well with the 2.9
x 9.5 mm stud bolt.
NO.
ELEMENT
1
10 mm Rawl Plug
2
Metallic fastener
3
Screw 2.9 x 9.5mm
4
Screw 6.3 x 50mm
5
Product
2.2. Connecting instructions
Connection to the mains must be made observing the voltage stated on the product technical data label.
This product is designed to be permanently installed connected to fixed facilities. The product power
supply circuit must have an all-pole circuit breaker switch with a separation of at least 3 mm between
the contacts.
The product must be installed, if possible, away from any source of draughts (windows, doors) or any
other thing which may affect its functioning. In this way, the temperature will not be affected. Place any
object which might prevent the air flow (furniture, armchairs) 50 cm away from the front of the product.
The product must never be installed immediately below a power point. The lower part of the control
panel must be placed at least 15 cm from the floor.
For any product, if the power cable is damaged, it must be replaced by a specific cable. The replacement
of the cable must be done by the Rointe after-sales service or qualified personnel. The technical
specifications of your product appear on the technical data label.
6
3
5
4
5
2
1
Publicidad
