z Charging the battery
The battery is charged in all operating
modes. To optimise initial charging, leave
the product switched off during charging.
Please note: The battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours. The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight.
Maximum illumination time when fully
charged: approx. 80 hours ("Mode 2")
z Operation
The product can be operated in three
different modes. The operating mode is
selected by means of the switch
Please note: The solar panel will turn on
the product in twilight or darkness and will
switch it off at dawn. It memorises the
selected mode.
Please note: Battery charging via the solar
panel does not depend on which mode is
selected. The battery is charged continuously
at all times.
Mode 1 (AUTO)
Press the button
3
The product will be switched on as soon as
the motion detector detects movement. It
will light up for approx. 30 seconds. If
another movement is detected in these 30
seconds, it will keep the light on for another
30 seconds. LEDs light up at full power in
this mode.
Mode 2 (NIGHT LIGHT)
Press the button
3
2�
The product will switch itself on
automatically at dusk. In this mode, LEDs
do not light up at full power, but only at
approx. 14 lm. The product will switch to
full power for approx. 30 seconds as soon
as the motion detector detects movement. If
60
GB/IE/NI/CY/MT
�
3
to activate Mode 1.
again to activate Mode
another movement is detected in these 30
seconds, it will keep the light on for another
30 seconds.
Mode 3 (50%ON)
Press the button
3
Mode 3.
The spotlight will be switched on with a
brightness of 50%. The motion sensor is
inactive in this mode.
Switch off spotlight (OFF)
To switch off the floodlight, press the switch
for a fourth time.
3
z Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on.
= The product is switched off.
= Press the switch
product (see section "Operation").
= The light is flickering.
= The battery is almost fully discharged.
= Charge the battery (see section
"Charging the battery").
z Cleaning and storage
Switch the product off if you want to stop
using it, store it away and/or clean it.
Regularly inspect the solar panel
soiling. Remove any dirt to ensure the
product works correctly.
Keep the product and especially the solar
panel free of snow and ice in winter.
Use only a dry, lint-free cloth for cleaning. If
the product is very dirty, dampen the cloth
slightly.
When the product is not in use, store in the
packaging in a dry place.
again to activate
to switch on the
3
for
1