Fiap proficontrol GENERAL Instrucciones De Uso página 9

GB
The running time in seconds (1 - 99), pause time in minutes (1 - 99) and the motor speed
in 99 steps for each output can be set using the buttons on the proficontrol
NERAL
control. The entire proficontrol
deactivated via a separate button. The settings are retained after the reset (switch off).
CONTROLS
2-digit 7-segment display
Keys: (+), (-), (T), (1), (2), (3), (4), (Active / Inactive)
LEDs: (Feed), (Pause), (Tempo 1), (Tempo 2), 4x channel LED, (active / inactive)
INSTALLATION
After installing the proficontrol
matic feeder you need to the control. The connected profifeed automatic feeders
are recognized after switching on the proficontrol
nels that are not connected remain without function and cannot be operated without a
connected profifeed automatic feeder. In order to be able to make settings for a channel,
the corresponding channel key is pressed. The activated channel is indicated by a flashing
channel LED.
The 4 LEDs below the display show the parameters that can be changed. Press the
channel button again to select the next parameter.
While the setting mode is active, the corresponding channel can be activated with the „T"
button (keep button pressed) and the desired power levels can be set for both outputs.
Pressing and holding the channel button (3 seconds) activates manual feeding and thus
the desired channel. The channel remains active as long as the button is pressed. The
time of manual feeding is shown in seconds on the display.
The proficontrol GENERAL control can be activated or deactivated via a button (active /
inactive).
Red LED inactive
LED green active
When connecting a new profifeed automatic feeder, the proficontrol
control must be set to inactive.
When the proficontrol
profifeed automatic feeder is recognized by the proficontrol
ERROR DETECTION
If the channel LED lights up continuously and the connected automatic feeder is not run-
ning, then the connection between the control and the motor is faulty (broken cable, plug
problem).
GENERAL
GENERAL
GENERAL
control is started up again, the newly installed
control can be activated or
control, connect the profifeed auto-
GENERAL
control. The chan-
GENERAL
FEEDING
GE-
GENERAL
control.
9