Publicidad
CAUTIONS AND WARNINGS
WARNING
Turn off and disconnect the power before installation. Installation should be performed by a qualified electrician in accordance with all national and
local electrical and construction codes and regulations.
• DO NOT attempt to install or use this product until you have fully read and understand the installation instructions contained in this user and
installation guide and on the product safety labels. Failure to follow the Fluence product instructions and safety label advice may result in damage
to the product, damage to property, or personal injury. Be sure to retain a copy of this user guide after installation for future reference.
• Risk of Electrical Shock. Turn off and disconnect the power before installing, moving, or cleaning to reduce the possibility of serious injury. DO NOT
disconnect cables from the power supply or LED light bar while energized.
• Only connect the system to an electrical outlet or circuit of appropriate type and rating for the cord and plug. Connect the system only to power
sources of the correct voltages and frequencies listed in the product specifications.
• Protect power cables from being pinched, walked on, or otherwise damaged.
• Use a strain-relief or power cord grip if needed. Maintain a minimum of 1" (2.5 cm) bend radius for all cables.
• Use IP wet-rated junction boxes and fittings for the power cords equal to the IP rating of the rating of the lighting system for the application.
• DO NOT connect to live power until installation is complete and all connections are made.
• DO NOT modify or alter the product; doing so will void the warranty. Please refer to the Fluence Terms and Conditions and Limited Warranty for
further details.
• LED and heatsink surfaces may be hot. DO NOT touch while in operation. Allow sufficient cooling time before handling.
• To reduce the risk of overheating or fire, never place operating fixtures face down on a flush surface. Always allow for adequate ventilation of
fixtures and power supplies.
CHEMICAL EXPOSURE PRECAUTION
Fluence lighting systems are designed to be resilient against crop protection products. Many chemicals used in the Commercial Horticultural Industry
are corrosive to electronic equipment. If the luminaire is accidentally exposed to a corrosive liquid or vapor (e.g. VOC –Volatile Organic Compound
and H2S – Hydrogen Sulfide) the luminaire must be rinsed with clean water as soon as possible. The product warranty will no longer apply if
the product is exposed or remains in the corrosive environment. It is recommended the luminaires be removed and protected from the corrosive
environment during all periods of disinfection or sanitization of the facility.
CALIFORNIA PROPOSITION 65 WARNING
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more
information: www.P65Warnings.ca.gov.
PHOTOBIOLOGICAL HAZARD SAFETY
Photobiological safety of lamps and lamp systems (IEC/EN 62471 and TR 62778). This International Standard describes the photobiological safety of
lamps and lamp systems, including luminaires. The rating of this product according to this standard can be found in the table below.
Ordering Code
Actinic UV 200-400 nm
VN-x-xx-BP6-MVG-xx
VN-x-xx-DR9-MVG-xx
CAUTION: POSSIBLY HAZARDOUS OPTICAL RADIATION EMITTED FROM THIS PRODUCT.
DO NOT STARE AT THE OPERATING LAMP. MAY BE HARMFUL TO THE EYE.
These photobiological safety markings are based on testing of the light output characteristic of a single horticultural luminaire. Increased exposure
risk to facility personnel may be present depending upon the number of horticultural luminaires and their placement and/or positioning within the
plant growth facility.
It is the responsibility of the plant growth facility to address these risks at the facility level and to ensure that people entering the plant growth areas
while the lights are on are aware of these risks and that appropriate safeguards are in place.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
ETL Rating: RAZR Modular Series fixtures are rated suitable for wet locations. A "wet location" is defined as an interior or exterior location in which water or
other liquids may drip, splash or flow on or against the electrical components of a lighting fixture. RAZR Modular Series fixtures and power supply are certified to
meet UL standards (ETL) from the Intertek safety consulting and certification company. Systems are cETL listed and are rated IP66 by IEC standard 60529.
The light source of this luminaire is not replaceable; when the light source reached its end of life the whole luminaire shall be replaced.
Horticulture Lighting, not suitable for household room illumination.
1 PPF calculations compiled using integrating sphere measurements at a steady state and typical spectroradiometric data for each LED to determine typical fixture performance. Actual photometric
results may vary within the LED manufacturer's bin tolerance.
2 Wattage values are typical expected values. Fluence maintains a tolerance of ±10% on flux and power specifications. Target light levels can vary from projected levels depending on ambient
temperature, room reflections values and dirt accumulation.
6
Radiation hazard -
Retinal Blue Light (small source) 300-700 nm
Exempt Group
(None)
Risk Group 1
(Low)
Retinal Blue Light Radiation Hazard - RISK GROUP 2
Radiation hazard -
Risk Group 2
(Moderate)
Risk Group 2
(Moderate)
CAUTION: UV EMITTED FROM THIS PRODUCT. MINIMIZE EXPOSURE
Minimum viewing distance
All Other Radiation Hazards
(meter/inch)
0.515 / 20.28
0.51 / 20.08
Actinic UV Radiation Hazard - RISK GROUP 1
TO EYES OR SKIN. USE APPROPRIATE SHIELDING.
Exempt Group
(None)
Exempt Group
(None)
Publicidad
