Tool Settings; Dust Extraction; Edge Protector; Sanding Motion - Festool ROTEX RO 125 FEQ Manual De Instrucciones

5.1
6.1
prox. 3-5 minutes before using it again. The tool
requires less time to cool down if it is running, i.e.
in neutral position.

Tool settings

from the socket before carrying out any work on
the power tool.
4.1
Always connect the tool to a dust extractor.
You can connect a Festool extractor with an
extractor hose diameter of 27 mm to the dust
extraction port (4.1).
The edge protector (5.1) prevents the sanding pad
from touching the edge perpendicular to a surface
(e.g. when sanding along a wall), thereby prevent-
ing the machine from rebounding.
Assembly: Slide the edge protector onto the ma-
chine until it latches into place.
You can use the switch (6.1) to set two different
sanding motions.
the sanding pad is stationary, as the switch is
locked in place during operation for safety rea-
sons.
Rotex rotary motion (coarse sanding, polishing)
The Rotex rotary motion is a combination
of rotary and eccentric motions. This mo-
tion is recommended for sanding with ag-
gressive material removal (coarse sand-
ing) and polishing.
Slide the switch (6.1) into the right position.
Eccentric motion (fi ne sanding)
This motion is recommended for sanding
with low material removal for a scratch-
free fi nish (fi ne sanding).
Press the switch (6.1) down and push it into the
left-hand position.
7
Always remove the power plug

Dust extraction

Edge protector

Sanding motion

The change can only be made when