Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installing the Bidet Attachment
1. Install adjustable mounting brackets into
the bidet attachment
Place circular mounting brackets into the
circular openings of the bidet attachment.
Step 1
2. Install bidet attachment on toilet
a. Place the bidet attachment on the toilet
with the nozzle close to the back of the
toilet, leaving a slight gap between the
toilet and the nozzles. This will vary by
toilet.
b. Make sure the adjustable brackets line
up with the holes in the toilet fixture.
You may need to rotate the adjustable
brackets accordingly to line up properly.
Step 2b
c. Replace the toilet seat on top of the bidet
attachment and secure using original
toilet seat hardware. Make sure to tighten
so that the bidet attachment and seat do
not move.
Step 2c
10
d. Ensure the bidet control knob is in the
off position and isn't turned to one of the
operating positions to prevent water from
accidently spraying out of the toilet bowl.
3. Connect bidet hose to bidet attachment
Connect the open end of bidet hose to the
cold connection under the bidet attachment.
Step 3
NOTE: If you have already installed the
hot water supply cap over the hot water
supply on your FSA-25 Dual Temperature
model, skip to Step 5 on Page 11.
Otherwise, proceed to the next steps.
4. Connect hot water tube to bidet attachment
(FSA-25 dual temperature model only)
a. Take the hot water tubing pressure
connector and remove the pressure cap.
b. Slide the pressure cap over the open
end of the of hot water flex tubing with
the inside threads facing towards the
open end.
Step 4b
Publicidad
