Grundig GDSP 2460 BC Manual Del Usuario página 14

INSTALLATION OF APPLIANCE _______________________
Installation of the Hood to the
Chimney
Make the electrical connection of your
hood before starting the installation of
the chimney. Slip the Chimney plates
around the body. Screw the Chimney to
the Chimney fastening plates available on
the motor cabin. (Figure 12).
Install the Chimney to the Chimney fas-
tening plate that is secured to the wall
from its upper outer edges (Figure 12).
(Fig. 12)
14 ENGLISH
Installation of Air Baffle
While using with the carbon filter, air baffle is
provided with your appliance with the aim of
re-releasing the air which is cleaned with car-
bon filter from the perforated located on the
chimney. Assemble the air baffle as below.
(Fig. 13)
There is a tab in the middle of the chimney
connection plate. Place the middle point of
this tab on the line that is drawn perpendic-
ular to the wall. Align horizontally and mark
the holes where the connection plate will be
mounted via a pen (Figure 13 / A, B).
Drill the marked points with Ø6mm drill and
insert two Ø6mm plastic dowels in the drilled
holes (Figure 13 / A, B).
Fix the Chimney connection plate to the wall
with 3.9x22 screws (Figure 13/ A, B).
For the assembly air baffle, drill points C, D,
E, F with a Ø6mm drill bit and tap the Ø6mm
plastic dowels (Figure 13).
Assemble cooker hood's body (Page 14 / Fig-
ure 9).