EGAmaster 57542 Manual De Instrucciones página 21

ATTENTION:
If an external force is applied to the torque wrench during power-on/reset or wake up period,
an initial torque offset will exist in the memory.
The wrench will auto sleep after about 5 minutes idle for power saving. Press
the wrench during the sleep mode.
CAUTIONS:
During communication period (Send appears), the sleep function is disabled.
- Press together will reset the wrench.
- If the wrench does not function normally,
Press together to reset the wrench.
If the battery serial voltage is in low voltage status, the wrench will display a battery symbol
and then turn off after a while.
- If you use the different head of the wrench, the reading on the display will be different for the
different length of the head. Please refer to the following explanation.
D : The set torque
D1: The actual torque applied to the nut.
L1: The extended length
L2: The normal length
L3: The length from the fitting pin to the calibration point.
ACTIVATION DURING SLEEP MODE
RESETTING THE WRENCH
LOW BATTERY VOLTAGE PROTECTION
WHEN CHANGING THE TYPE OF HEAD
Calibration Point
to wake up
21