The pump may only be operated with 14-V protected
low-voltage in combination with the GARDENA plug-in
power supply for pump.
Protect from rain. Use the plug-in power supply only in
a rain-protected area.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also
a risk that the polybag can suffocate toddlers. Keep
toddlers away when you assemble the product.
2. INSTALLATION
DANGER! Risk of injury!
Risk of injury when the product starts
accidentally.
v Disconnect the product from the mains before
you install the product.
A video of the
setting processes
is available here:
(J)
Drip distributor
:
There are 3 drip distributors
tion rates.
(a)
– Light grey
:
For plants with low water requirements:
(b)
– Medium grey
:
For plants with average water requirements:
(c)
– Dark grey
:
For plants with high water requirements:
If a plant has a water requirement of over 60 ml per day,
you will need to use more than one drip pipe for the plant.
3. OPERATION
DANGER! Risk of injury!
Risk of injury when the product starts
accidentally.
v Disconnect the product from the mains before
you fill the water reservoir.
To start the irrigation [ Fig.
CAUTION!
Damage to the pump if it runs dry.
v Make sure that the water reservoir is always
sufficiently filled with water.
10
13366-20.960.03.indb 10
13366-20.960.03.indb 10
(J)
with different daily applica-
15 ml/day
30 ml/day
60 ml/day
(5)
]:
Only use Original GARDENA parts, as the function of the
system cannot otherwise be guaranteed.
Do not let the pump run dry.
Observe the minimum water level in accordance with the
technical Data given for the pump.
Do not use the product while you are tired or under the
influence of drugs, alcohol or medication. A moment
of inattention while you operate the product may result
in serious personal injury.
Do not open the pump further than delivery status
(only exception: the foot).
Preparation:
1. Group your plants in 3 groups according to their water
requirements.
2. Use planters or saucers so that any excess water will
be collected.
3. Allocate the individual drip distributors to the groups.
4. Place the water reservoir close to the plants and
a power supply.
Fig.
(1)
:
Each drip distributor must be individually connected to the
pump.
To calculate the water quantity:
[ Quantity of plants x daily water requirements in ml
(15, 30 and / or 60) ] x days
CAUTION!
The plants must be positioned above the water
level of the water reservoir to prevent the water of
the reservoir from flowing out via the supply pipes.
(A)
1. Fill the water reservoir
with the previously calculated
amount of water (make sure that the water reservoir
stands in a secure position).
2. Place the pump in the water reservoir
(make sure that the pump is level with the bottom of the
(A)
water reservoir
).
(B)
3. Connect the pump
to the power adapter
(C)
4. Plug the power adapter
The irrigation will start for 1 minute and the LED will
illuminate green.
5. During the first irrigation, check all connections for leaks.
The irrigation will be repeated daily at the same time as the
power adapter was plugged in.
(A)
(A)
filled with water
(C)
.
into an electrical socket.
19.05.22 10:33
19.05.22 10:33