T-Mech 210410 Manual De Instrucciones página 9

USER GUIDE
OPERATING INSTRUCTIONS
1. Always warm up the engine without any load for approx. 3 minutes before attaching
any loads.
2. Check that there no abnormal vibrations or sounds. Check if the engine is misfiring.
Check the colour of the exhaust gas – is it too light or too dark? If you notice any of
these occurring, then switch off the generator.
3. Do not adjust the speed limit regulation bolt or the fuel adjustment bolt as these have
been factory set.
AC OPERATION
1. Increase the speed of the engine to maximum using the engine speed lever
2. Check the voltmeter. Once it points to 230V +/- 5% you can connect an appliance to
the generator.
3. When connecting appliances to the generator, always connect the largest load first.
4. If overloading of the generator causes the AC circuit breaker to trip, reduce the load on
the circuit.
NOTE: Do not start two connected appliances simultaneously. Start one at a time.
If you have connected floodlights to the generator do not connect any other appliances.
DC OPERATION
The DC terminal is only to be used for charging 12V car type batteries.
1. Always disconnect the negative battery cable (Ground cable) before connecting
battery to the generator
2. Start the generator.
3. Connect the charging cable to the battery terminals and then to the generator.
4. Once the battery is charged always disconnect the cables at the generator first.
NOTE: DO NOT reverse the charging cables as this will damage the generator and battery.
Batteries can produce explosive gases while recharging. Charge batteries in a
well-ventilated area.
210410/210411 - T MECH DIESEL GENERATOR
09