3M DBI SALA NANO-LOK 2000044 Manual Del Usuario página 20

Inspection Date:
Components: Inspection:
Connected Sensor Inspect the Housing (D), Adjustment Clamp (E), and Pairing Button (F) for
Box (Figure 2.1) damage: Look for cracks, dents, and deformities.
Inspect the lens for smudges or dust that could interfere with user detection.
Ensure that the Adjustment Clamp and its adjustment bolt move freely and secure
properly.
Verify that the Power Input (A), the power cable, the Feedback Output Plugs (B),
and the Feedback Lights (C) are free of any cuts or abrasions. The cables should
be fully secured at each connection point and there should be no loose portions of
wire.
Nano-Lok SRD Inspect for loose fasteners and bent or damaged parts.
(Figure 2.2)
Inspect the Housing (C) and Cab Mount (E) for damage: Look for cracks, dents,
and deformities.
Inspect the Swivel (D) for distortion, cracks, and deformities. The Swivel should be
attached securely to the SRD, but should pivot freely.
The Lifeline (A) should pull out and retract fully without hesitation and without
creating a slack line condition.
Verify that the integral Energy Absorber (B) has not been activated. An open cover
or torn cover, webbing pulled out of the cover, torn or frayed webbing, ripped
stitching, etc. are indicators of an activated Energy Absorber.
Ensure the SRD locks up when the Lifeline is jerked sharply. Lockup should be
positive with no slipping.
Inspect the entire SRD for signs of corrosion.
Connected Inspect the Connection Eye (A) and Shroud (C) for damage: Look for cracks, dents,
Aluminum and deformities.
Carabiner
Verify that the Gate (B) opens and closes freely. The gate must fully open and
(Figure 2.3)
close.
Inspect the entire Carabiner for signs of corrosion.
Labels (Figure 13) Verify that all labels on the system are present and fully legible.
Fall Protection Additional Fall Protection equipment that is used with the product should be
Equipment installed and inspected per the manufacturer instructions.
Serial Number(s):
Model Number:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Table 2 – Inspection and Maintenance Log
Inspected By:
(See Section 5 for Inspection Frequency)
Date Purchased:
Date of First Use:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Competent
User Person
Next inspection due:
Next inspection due:
Next inspection due:
Next inspection due:
Next inspection due:
Next inspection due:
Next inspection due:
Next inspection due: