Publicidad
Idiomas disponibles
Idiomas disponibles
B2
21
B3
1
2
4
1. Attach the coupler (21) to the end of the blower
tube.(See Fig.B2);
2. Insert the coupler, together with the blower tube,
into the flexible tube.(See Fig B3
clamp on the end of the flexible tube as shown(See
1 2
Fig B3
);
3. Tighten the clamp with screws as shown.(See Fig
B3
1 3
).
Note:Screw tightening torque value should be set
between 10.6 in∙lb(1.2Nm) and 14.2 in∙lb(1.6Nm).
Ffit an auxiliary nozzle(See Fig B4)
B4
1
2
1
2
1
2
3
1
).Then put the
1
2
3
1. Match the "
" between the blower tube and
1
blower nozzle(
);
2. Push the nozzle onto the the blower tube along
the thread(
1 2
).
3. Twist the blower nozzle in the direction shown to
lock inthe blower nozzle(
Assemble the control handle(See Fig
C1,C2,C3)
C1 A
19
1
2
C2 A
20
C3 A
1. Open the front handle clamp and move it to the
desired place, then close the front handle clamp as
shown(See Fig C1).
2. Assemble the control handle with screws as
shown.(See Fig C2).
1 3
).
1
2
1
2
1
2
22
EN
11
Publicidad
