Part Names; Front Panel - Onkyo TX-NR474 Manual De Instrucciones

> Before Start > Part Names

Part Names

Part Names


Front Panel

1. Í ON/STANDBY button
2. PURE AUDIO button/indicator: Switches the unit to Pure Audio mode (P38).
3. HYBRID STANDBY indicator: Lights if the unit enters standby mode when the features
are enabled that continue to work when this unit is in standby, such as HDMI Standby
Through and Network Standby.
4. Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 16y/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
5. TUNING MODE button: Switches tuning to an AM/FM station between automatic tuning
and manual tuning.
6. DIMMER button: You can adjust the brightness of the display in three steps. It cannot be
turned off completely.
4
> Install
    
  
> Initial Setup > Playback
 

7. Display(P5)
8. SETUP button: You can show advanced setting items on the TV and display to provide
you with an even better experience (P52).
9. Cursors ( / /
ENTER to confirm. Use them to tune to stations when using TUNER (P29).
10.RETURN button: Returns the display to the previous state during setting.
11. MASTER VOLUME
12.PHONES jack: Connect stereo headphones with a standard plug (Ø 1/4z/6.3 mm
diameter).
13.TONE and Tone Level buttons: You can adjust the sound quality of the front speakers.
Press TONE to select the desired setting from "Bass" and "Treble", and adjust with the
Tone Level buttons (-/+).
14.MEMORY button: Used to register AM/FM radio stations.
15.Input selector buttons: Switches the input to be played.
Advanced Setup | Supplementary Information | Others
 
  
/ ), ENTER button: Select the item with the cursors and press
