24. Dismantling MUST be carried out by a qualified technician whom MUST use the
PPE correctly and MUST perfectly know the equipment.
All the refrigerants MUST be recovered safely; always collect a sample of oil
and refrigerant before emptying the circuit.
25. Before starting any dismantling operation:
- Electrically insulate the system.
- Ensure that you have mechanical handling equipment at your disposal to
handle the tanks, if necessary.
- The equipment and recovery tanks MUST be in compliance with the standards.
26. The equipment must be labelled indicating that it has been deactivated and
emptied of refrigerant. The label must be dated and signed.
Make sure that on the equipment are present labels indicating that the equipment
contains flammable refrigerant.
27. If the compressors or compressor oils must be removed, it is necessary to
check that they have been extracted safely and at an acceptable level to ensure
that the flammable refrigerant has not remained inside the lubricant.
The evacuation process must be carried out before returning the compressor
to the suppliers.
To speed up this process, only electric heating of the compressor body must be
used.
0.5 - PROPER USE
• The air-conditioner should be used for the exclusive purpose of producing
hot or cool air (on demand) for the sole purpose of obtaining a comfortable
temperature in the room.
• Improper use of the machine (outside and inside units) causing damage to
persons, property or animals relieve OLIMPIA SPLENDID of any liability.
0.6 - HAZARDOUS ZONES
• The climate controllers must not be installed in environments with the presence
of inflammable gases, explosive gases, in very humid environments (laundries,
greenhouses, etc.), or in places with other machines that generate a strong
heat source, in proximity of a sources of salt water or sulphurous water.
• DO NOT use gas, gasoline or other inflammable liquids near to the climate
controller.
• The climate controller does not have a fan for the introduction of fresh outdoor
air into the room; ventilate by opening doors and windows.
• Always install circuit breaker and a dedicated power circuit.
This product must be used exclusively according to the specifications
indicated in this manual. Use different to that specified, could cause serious
injuries.
THE MANUFACTURER IS NOT LIABLE FOR INJURY/DAMAGE TO
PERSONS/OBJECTS DERIVING FROM FAILURE TO COMPLY WITH THE
REGULATIONS CONTAINED IN THIS MANUAL.
EN - 11
ARYAL S1 E