Publicidad
Idiomas disponibles
Idiomas disponibles
A suitable omnipolar disconnection device must be envisioned on the appliance
mains electric power supply, in compliance with the national installation rules.
It must be checked that the electric power supply has an effective earth and suitable
protections against overloads and/or short circuits.
The use of a ceramic fuse of the characteristics shown in the table is advised (or
other devices with the same functions).
The connection to the mains power supply must be made by the installation
technician (excluding mobile appliances, for which fixed installation by qualified
personnel is not required) in compliance with the regulations in force.
BEFORE MAKING THE ELECTRIC CONNECTION, MAKE SURE THAT THE UP-
STREAM ISOLATING SWITCH IS AT "0" (OFF) AND THE PROTECTIONS OF THE
INDOOR AND OUTDOOR UNITS ARE POSITIONED CORRECTLY.
d. Connect the power supply cable terminals (32) (not supplied) to the terminal board (28) positioned in
the outdoor unit electric connections compartment.
e. Before re-installing the protection of the electric connections, fix the power supply cable via the relevant
cable tie (31), positioned in proximity of the outdoor unit terminal board (28).
2.7.5 - Delivery of the system
When all checks and controls regarding the correct operation of the plant have been completed, the installation
technician must illustrate the following to the purchaser:
- the basic operational features,
- the plant switch-on and switch-off instructions,
- the normal use of the remote control,
- the first practical advice for routine maintenance and cleaning.
3 - USE AND MAINTENANCE
3.1 - USE OF THE REMOTE CONTROL
The remote control supplied with the air-conditioner is the
instrument that enables you to use the appliance in the most
convenient way.
It should be handled with care and in particular:
• Keep it dry (do not clean it with water or leave it outdoors in
bad weather).
• Avoid dropping or bumping it.
• Keep it out of direct sunlight.
• The remote control operates by means of an infrared beam.
• During use, there must not be any obstacle between the remote control and the air-conditioner.
• If other appliances in the room have remote controls (TV, stereo, etc...), there may be interference.
• Electronic and fluorescent lights may also interfere with transmissions between remote control
and air-conditioner.
• Remove the batteries in case of prolonged disuse of the remote control.
EN - 28
Publicidad
