Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Tips ... Before you call for service
Problem
Unable to set cook time or
delay time
Oven racks are difficult to
slide
Drawer does not slide
smoothly or drags
Steam from the vent
Water remaining on oven
floor after Steam Clean
cycle
Oven will not steam clean
Display prompts for Probe
Temperature
49-80806 Rev. 4
Possible Cause
You forgot to enter a cooking mode first.
The shiny, silver-colored racks were
cleaned in a self-clean cycle.
The drawer is out of alignment.
unbalanced.
When using the ovens, it is normal to see
steam coming out of the oven vents. As
the number of racks or amount of food
being cooked increases, the amount of
visible steam will increase.
This is normal.
Oven controls improperly set.
Oven door is not closed.
This is reminding you to enter a probe
temperature after plugging in the probe.
What To Do
See the Options section
Apply a small amount of vegetable oil to a paper towel and
not spray with Pam
®
or other lubricant sprays.
Fully extend the drawer and push it all the way in See the
Care and cleaning of the range section.
Reduce weight. Redistribute drawer contents.
This is normal.
Remove any remaining water with a dry cloth or sponge.
Allow the oven to cool to room temperature and reset the
controls.
Make sure you close the door to start steam clean cycle.
Enter a probe temperature.
29
Publicidad
