Connecting Up; Connecting Antennas - JVC EX-A1 Manual De Instrucciones

Connecting up

Connecting antennas

Connecting AM loop antenna (supplied)
1
Set up the AM loop antenna.
2
Connect antenna cords.
Main unit
(rear panel)
Black White
3
Turn the AM loop antenna to the direction of the
best radio reception.
Locate the AM loop antenna as far away from
the main unit as possible.
• Do not locate the AM loop antenna on a metallic
table or close to a TV, personal computer, etc.
Otherwise it may result in bad radio reception.
7 When good radio reception cannot be
obtained with the supplied AM loop antenna
Electric wire: 3 - 5m (commercially available)
Electric wire
Twist
AM loop
antenna
Main unit
(rear panel)
When positioning the antenna, listen to an actual radio program (refer to "Listening to a radio broadcast" on page 33).
9
– Do not turn on the power until the connection is complete –
How to insert antenna cords
Connect two antenna cords
as described above.
If the antenna cord is
covered with vinyl on the
tip, twist and pull the vinyl
off and remove.
Put up an electric
wire extending
horizontally,
preferably at a high
place such as
above a window or
outdoors.
Connect the AM loop
antenna cords together.
Connecting FM antenna (supplied)
FM antenna
Main unit
(rear panel)
Put the antenna up straight in the direction where
the best radio reception can be obtained, and fix
by using tape.
7 When good radio reception cannot be
obtained with the supplied antenna or when
using a communal antenna
Antenna cord (sold
separately)
or
Converter
Main unit
(sold separately:
(rear panel)
compatible with 300C/
75C)
Depending on the radio reception
conditions, an FM feeder antenna (sold
separately: compatible with 300C) can
be used. In the case, a converter (sold
separately) is required.
For details of connecting a separately sold
antenna, refer to the user guide for the antenna
or converter.
Connection
Communal
antenna terminal
Outdoor FM antenna
(commercially
available)
Coaxial cable
(commercially
available)