Front Runner FAVT001 Instrucciones Para El Montaje página 5

3
FIT THE RACK
Note: If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal
Assembly Instruction (Document RRSTUNI). Read Step 3A before fitting the Wind Deflector
Before fitting the Wind Deflector, and with
( A )
the Rack in the upside down position, (Check
that the product sticker. It should be upside
down), slide a M8 x 20 Hex Bolt (Item 3) into
each end of the First Slat using the machined
slot as shown.
With your Rack still upside down position from Step 3A, slide a M8 x 20 Hex Bolt (Item 3) into either end of
( B )
each of the following Slats as per the diagrams below.
Full Rack KRVK005T
Half Rack KRVK004T
FAVT001_REV_A00
5