Publicidad
Idiomas disponibles
Idiomas disponibles
FIT THE RACK cont...
( C )
Grab your Friend and with one of you on each side of the Rack, flip the Rack end over end (This
prevents the Hex Bolts from falling out of the machine slots) so that the M8 x 20 Hex Bolts are facing
down. Approach the vehicle from the rear, with the Wind Deflector facing forward. Lift the Rack up and
over the Roof, positioning it above the Foot Rail. Bring the Rack down slowly, lining up the Bolts in the
Rack with the holes in the top of the Foot Rail. Hand tighten the Rack to the Foot Rail using the M8
Washers and M8 Nyloc Nuts (Items 4 & 5) supplied.
Center the rack - left to right (check using a tape measure). Fasten all the Nuts securing the Rack to
the Foot Rail. Cover the M8 Nyloc Nuts with the M8 Nut Caps (Item 6) supplied.
Congratulations, you have completed your instillation. Take a step back and admire your work. Good Job!
TAKE A TRIP
After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where
( A )
needed. You'll find a small amount of settling has happened.
Go on many more adventures, periodically checking all nuts, bolts, screws and fittings.
Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle
manufacturer's recommendations.
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
Now's the time to visit your favorite Front Runner dealer in person or online.
( A )
FAVT001_REV_A00
6
Publicidad
